PDA

View Full Version : Aluminum drive shaft?


allmotor85supra
03-18-2003, 10:19 PM
Does any know who make a one piece aluminum drive chaft to get rid of the carrier bearing?
82Spearco
03-18-2003, 11:22 PM
Jim Jobe can get you a one piece lightweight driveshaft. He is located in Central Ohio. Dont have his email handy, but James Razor should know it. Seems like it was around $350 or so.
Norbie
03-19-2003, 03:58 AM
Are you sure you want a single-piece shaft? It will be impossible to install or remove without removing the transmission at the same time... talk about a PITA.
SupraFiend
03-19-2003, 04:32 PM
or the diff you mean. 1 of the 2, hard to say which is less of a PITA.
SupraWes
03-19-2003, 06:08 PM
Just put a flange on it like the 2 piece stock shaft has.