KesekiSupra
09-25-2005, 05:21 PM
i work on it like one hour a month, but its finally almost done, just two things, one that made me blow my top, and one that didnt. this is on a 4me so it might be diff from the 5me, on top of the thermostat housing is a 2 pin male connector. im guessing its the temp sens. correct? its green. theres these two brown wires that are stripped/cut, im guessing they go them since they are female and they're the only wires left that havent been hooked up. i wanna know which wire goes on the right (look at it from the drivers side looking towards pass side fender) and which goes on the left (i put yellow left brown right as of now but havent even installed the battery to check yet)
last thing, theres a coolant line that goes from under the intake mani (off the block) to on top of the mani. this one i have hoooked up, but now if u follow the line from the block left (on the same junction pipe (i guess this is the word?)) there should be another coolant line there (i filled up the rad and coolant came pouring out so this i know) now wat im MISSING. is where the hell does that connect to? goes from there to the block again? or another part on the mani? or is it just plugged? ill try to get a pic but its hard cuz everything is in its way. maybe a certain mk1 guru came chime in? ;)
last thing, theres a coolant line that goes from under the intake mani (off the block) to on top of the mani. this one i have hoooked up, but now if u follow the line from the block left (on the same junction pipe (i guess this is the word?)) there should be another coolant line there (i filled up the rad and coolant came pouring out so this i know) now wat im MISSING. is where the hell does that connect to? goes from there to the block again? or another part on the mani? or is it just plugged? ill try to get a pic but its hard cuz everything is in its way. maybe a certain mk1 guru came chime in? ;)