Hubs wont go on.

[jekruger72]

I'm trying to put the driver side rotor hub back on and I cant. I replaced the inner wheel bearing, but I didn't have the toyota tool so I made my own thing that I believe works the same just sits ontop of the oil seal and hits it down. Any ways the hub wont go all the way back. It has like an inch an a half left then when I try to pull the hub back off it gets stuck on something. The passenger side went on just fine. But I didnt replace the wheel bearing. Just wondering if it has happened to any one before. Or is it just fighting me.

Thank you

[Shift]

the inner bearing race could not be installed all the way

[kmfdmk]

the inner bearing race could not be installed all the way

Yeah the inner race should be completely flush on the stub.

[jekruger72]

ok. is there an easy way to remove the oil seal with out damaging it? So can check the inner race.

[jsn_ayers]

Tap it gently from the inside. do not use a screw driver. Or tap out the race and the seal will follow.

[jekruger72]

ok. Thanks guys

[jekruger72]

Problem solved. you guys will probably make fun of me but the rotor was on backwards. Haha

Thanks for the help.