Toyota Celica Supra Forum banner

Reaction score
61

Marketplace Rating
(0.0 - 0 reviews)

Profile posts Latest activity Discussions Buy & Sell Reviews Albums Showcase items About

  • · Registered
    Joined
    ·
    4 Posts
    Hi CarFreek,


    Im in Auburn and I tried to send you a message but your box was full. Im was wondering if you might know where I could get a left rear wheel well fender???


    Thanks

    · Registered
    Joined
    ·
    45 Posts
    your inbox is full but, cool im going to have to check that out because i'm also dropping my car 3-4 inches all around from stock height. so the camaro shocks would definitely be needed. i already have the front coilover assembly ready to put in with the cut strut housing and everything. So thanks for the info will definitely be looking into the camaro shocks. thanks for the info!

    · Premium Member
    Joined
    ·
    6,149 Posts
    Coil should work as mentioned. Constant Voltage is applied thru harness, and ignitor pulls it to ground when told by computer. Msns doesnt support Multiplex ignition ignitors like 7MGTE. There is a writeup on their site on using other ignitors to fire 7M coils. With Msns, and no built in ignitors, you could run "smart' COPs that have ignitors built in, also.

    · Premium Member
    Joined
    ·
    6,149 Posts
    Hi. Are you using 7MGTE Ignitor with MSnS? The 7MGTE uses a multiplexed signal from ecu to ignitor, then coil is fired. Coil is Dumb-IE should work how you describe. Theres a writeup somewhere on MSnS forum on using non multiplex ignitor(s) to fire 7m w/msns. You "could" also use COPs with ignitors built in, firing on waste spark, direct from Msns. Today is bad day, I can call Monday. Have a good day.

    · Registered
    Joined
    ·
    96 Posts
    yo, could you give me a call when you get this? I have a couple questions about the way the stock ignition coils work... I thought when you pull ground from the ground terminal, it's supposed to spark through the plug, but I've read different on cs.com. If you'd rather just pm, that's cool too, but my phone is 425-772-1481.

    Thanks for your time,
    Alec
  • Loading…
  • Loading…
  • Loading…
  • Loading…
  • Loading…
  • Loading…
  • Loading…
Top