I am in the middle of an engine rebuild on my 85 and I can't seem to find any good info on the 5MGE. I have done some measurements with a graduated cylinder and clay on the piston but I just wanted to check and see if anyone had these numbers or has done any measuring so we can compare numbers.

Serviceable limit (How much material can I remove) on the Cylinder Head or Engine block? ( I have seen 0.006" for cylinder head, but that seems tiny)

Piston Dish/Dome volume (measured about -1.5cc)

Combustion Chamber volume (measured about 50cc)

Factory gasket thickness (1.2mm or 0.047")

Piston to valve clearance (measured between 0.110" exhaust and 0.105" intake and this was with a 1.4mm or 0.055" head gasket)

These numbers are usually not that hard to find on other engines, but I guess that's what makes the 5MGE so special!