PCV Issues.

[rtomascik67]

Fully rebuilt long block. I need to clean pcv system on my 5mge. It's blowing oil into combustion chambers. Does anybody know where to start?

[4SFED]

Does anybody know where to start?

Replacing this this hose might be a good start.

[ddd228]

THAT is a special hose! I bought on from a Toyota dealer.Part number? That hose can be pinched by the distributor housing!
It snakes down to the crank case.
See this post by (God) Mark:
May not be available from him.
https://www.celicasupra.com/forums/s...nucks-eh-)#top

[Borg4d]

I also have this problem. With 374,000 miles on it, I think I am getting a lot of blow-by when down shifting, and the engine gets pushed. Enough that it pops the dipstick up out of the tube and dumps a little oil on hot exhaust. Instant smoke screen!!
I read that there is a venturi in the intake manifold that needs cleaned out, but I can't find it.
I tried putting a vent in the hose that was indicated in the above post, but now it just pushes oil out of there. Less smoke, but that whole side of the bay is an oily mess. And when I drive sporty, I have to add oil twice as often as I add gas.
Yes I know that sooner or later I am going to have to admit the engine needs rebuilt... but I will still need to find that venturi

[ddd228]

Your engine has a lot of miles,like mine was. I used 15-50 oil towards the end of its days with reduced oil consumption and less smoking. There is a restricted orifice on the rear of the Throttle body.I tapped into it for my catch can.

[Atl_Racer]

Fully rebuilt long block. I need to clean pcv system on my 5mge. It's blowing oil into combustion chambers. Does anybody know where to start?

what rings are you using? and did you measure the end gaps?