Toyota Celica Supra Forum banner

Discussions Showcase Albums Media Media Comments Tags Marketplace

1-8 of 8 Results
  1. Celica Supra Build Up / Restoration
    Engine pull went really smoothly. We basically just followed the TSRM and ignored where it said to take off engine accessories haha, there was plenty of room and it came right out even with the AC compressor, headers and intake on it. Discovered that I actually have a 6M block, and oil is...
  2. Engine / Intake / Exhaust
    Hey guys, I just rebuilt my 6mge, how do I make sure cams are in correct timing? I know there’s notches on cam gears and timing cover but how do I make sure that is it on cyl1 compression stroke? And that exhaust cam is in correct timing also? Obviously will make sure cyl1 is at top dead...
  3. Restoration Talk
    Once I started working on my Celica I was surprised by the lack of aftermarket support especially when it came to my floppy mirrors, you'd think that something so critical would have a replacement part. So after searching the forums and finding a few fixes that seemed to take a bit too much work...
  4. Engine / Intake / Exhaust
    looking for someone in calgary alberta that could help or lead me to someone that could help me rebuild a 5M (I think the bottom end needs rebuilding but I may need further assistance with finding the direct problem which is engine knocking)
  5. Engine / Intake / Exhaust
    Found these guys the other day whilst searching for turbo rebuilders. G-Pop Shop 22349 W War Eagle Rd Springdale, AR 72764 Ph: 479-751-7966 Fax: 479-717-2211 I contacted them yesterday by email, around 5pm. I had a reply first thing this morning from Gerry, the owner, just like their phone...
  6. 5MGTE/6MGTE/7MGTE - turbo forum
    i have a question about stock turbos such at the ct26 can these be rebuild to build more pressure for more do you definitely have to buy an aftermarket turbo
  7. Engine / Intake / Exhaust
    I was going to buy some main bearings from my local auto parts store. They asked me which set I needed- there is one set for 5m's made before 9/1984 and another set for engines made after 9/1984. This was news to me! I have a 5mge that I swapped into my pickup. I cannot remember which block I...
  8. Engine / Intake / Exhaust
    I'm rebuilding my 6M and understand the differences that the 6M brings to the rest of the motor, but my question is what torque specs should I use when putting it back together? Options are: A.) Since it's a 7M crank and rods, should I use the torque specs for the 7M when putting the mains and...
1-8 of 8 Results
Top