Toyota Celica Supra Forum banner

1 - 2 of 2 Posts

·
Registered
Joined
·
2 Posts
Discussion Starter #1 (Edited)
Got this to swap into my 4runner, needless to say I didn't do my research as the earlier block wont accept a dipstick for a mid sump pan (to clear steering) so I figured other people may need parts. I don't know much about this engine other than it has a bad intake cam, I'm sure the crank is not the best shape after metal from the cam has run through it but I haven't pulled a bearing cap to verify. The sump screen is clean and there is no play in any of the rods. What you see is all I have I'm keeping the motor mounts for a 7m later down the road. No part to small and I have no problem stripping this if someone wants the block or pistons etc. Make an offer on anything, paypal ready and I can ship on buyers dime, located in Bellingham Washington. Thanks for looking-Kyle

Email: [email protected]
Phone: (360) 393-5395




15086
15089
15087
15088
 

·
Registered
Joined
·
2 Posts
Discussion Starter #2 (Edited)
valve covers-SOLD
oil pan-SOLD
ecu-SOLD
crank pulley and water pump pulley-SOLD
power steering assembly is off and boxed but still available
 
1 - 2 of 2 Posts
Top