Toyota Celica Supra Forum banner

1 - 4 of 4 Posts

·
Registered
Joined
·
1 Posts
Discussion Starter #1
I am looking at purchasing a 1984 Celica supra with a 6MGE swap(3.0L, 5 angle valve job, milled head). I was going to drive it stock this winter then add more power via ebay t3(turbo) @5-6 psi. I can't find a proper exhaust manifold. I know about mid range honda engines(b18, b20) so this a bit of a jump for me. Any suggestions?
 

·
Super Moderator
Joined
·
8,135 Posts
Any 7m exhaust manifold will fit with a little grinding around the power steering pump bracket. There is stock, original JDM, and Chinese knockoffs out there. Most are all T4 base though. T3 turbos are kind of small for these cars.
 

·
Registered
Joined
·
48 Posts
Hello there , I’m selling mine , it has a 7MGTE , it’s not really a daily driver as it has a 10pt roll cage , lots and lots of custom goodies , including a custom fabricated exhaust header that allows a 74mm turbo to get full boost by 3000 rpm , a haltech which is programmed to drive , msd ignition and , EBC . Has boost , rich lean and ignition trim knobs that work live and lots more . Here’s a few videos until I can post pics .

https://youtu.be/c9nV1I2dbt8

this second video was back when I only was getting 13 psi and had not programmed the EBC function

https://youtu.be/GAW-XoeRpbA
 
1 - 4 of 4 Posts
Top