These aren't just good, they're seriously good. There is NO slop in the shifter whatsoever. With my cut down shifter there was a very slight increase in noise, but otherwise it runs just like stock, only the shifter is now Snap On ratchet precise.
Alright, got all my bushings in and modified, everyone paid up to this point (7pm EST) will get their bushings shipped out tomorrow morning (including overseas).
This begins a new batch, so don't worry if you still want one. Send your payments now and I'll let you know when we hit 20 sets again.
I know there are still tons of you guys out there that NEED these. Quit delaying and jump on the wagon. Don't let there be a time in two months where you go "damn, wish I had ordered those $35 bushings when I had the chance".
sheesh... i ordered two sets and im wondering if i should get more cause i know i'll be getting more mkii's down the road, plus my current third that i have no idea what tranny i'll be running... may hit you up again before this closes up...
Jose, they'll still be around, but expect prices to climb. These derlin bushings aren't cheap to begin with and resellers are going to have to account for the cost of carrying stock once I'm through with it as well.
Thanks Armin, but I'm really not in the business of reselling something I have no hand in manufacturing. With my kits, I make the bronze bushing. It's THE integral part of the system. Infact, if I weren't sure that 75% of the people would buy my $10 bronze piece, and find out the marlin cralwer derlin bushings are $25 and skip them, I'd sell them without the derlin bits. My goal is SUPREME shift feel. I feel good knowing that I've forced more than 70 buyers into a full set, removing all temptation to cheap out.
I finished it up a little earlier this year due to technical issues, didn't want to lose access to my files again so here it is
Hey guys and gals,
I went back to the drawing board and came up with a new design, using new materials.
Three layers carbon fiber (3K mesh + uni-directional cf) dry-laminated into form with Exp UV resistant epoxy.
The center holes have been reduced in size and cut with water jet. Side...
Originally developed these for my cf cooling panel: Toyota Katakana polyurethane hood stoppers/dampeners
OEM fitment on posts, they provide hood support and absorb shock
they can also be modified to fit several locations
^ test unit dirty after months of daily use, but no...