Toyota Celica Supra Forum banner
1 - 1 of 1 Posts

·
Registered
Joined
·
1,666 Posts
When I was taking apart my 7M I had the same problem. The impact gun alone just wouldn't do it, and my gun is a Snap-On so it's pretty powerful.
What I ended up doing was using a propane torch to heat the pulley right around the bolt. Careful not to get too close to the rubber dampener layer of the pulley. After I heated it for about 5-10 minutes it came out (with the impact gun) like it was barely in there in the first place.

HTH
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top