Toyota Celica Supra Forum banner
1 - 2 of 2 Posts

·
Premium Member
Joined
·
10,626 Posts
Just wetsand it level and spray it again.

That clear wouldn't be a blender would it? Did you have to mix it to prepare it? If not its probably a blender clear. That stuff is meant to hide the line where your clear ends if your not painting an entire panel. Its usually done on pillars. That stuff behaves exactly as you described, its very thin and dries very quick. It will not give you a deep glossy clear. Try a normal 3 part clear next time, a low pressure high volume gun might help a little in those tight confines too.
 
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top