Toyota Celica Supra Forum banner

1 - 5 of 5 Posts

·
Registered
Joined
·
1,267 Posts
Discussion Starter #1
My dilemma: An engine swap puts my w58 transmission about 1" forward of its original position. I will need a slightly longer front driveshaft to ensure full spline contact.

Someone mentioned that a Celica GT automatic has a slightly longer front section. Does anyone have Celica and Supra sections in manual and auto that you can measure (end of spline to flat face that meets the rear driveshaft)?

My car is an 85 manual Supra so I have that measurement. If worse comes to worst I'll have the current one lengthened, but would rather have an OE part if possible.
 
1 - 5 of 5 Posts
Top