Toyota Celica Supra Forum banner
1 - 1 of 1 Posts

· Registered
Joined
·
712 Posts
I replaced mine, and didnt have to remove anything. Just use a long screwdriver to hold the linkage in place, then there is a ball that pops into it on the motor itself. To move the linkage inside, move the wiper blades and grab it, it usually falls down, so you have to kind of reach down in there, but if the wipers are in the down position, it is too far over. It is kind of a pain, but not too horrible.
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top