[ma71supraturbo]

I have the mk2 99% assembled now, but there are two vacume lines that go from the powersteering area to the passenger side of the valvecover. Unfortunately, I do not have the intake hose that goes from TB to the afm, so I'm working on a temporary custom job. If these hoses go to the intake hose I need to know, but I can't find then pictured in the online TSRM.

Also, there is one vacume port on the intake manifold -- below the brake booster hose. Where does this go?

Thanks!

Jeff

 

[ma71supraturbo]

Also, how do I check to make sure I have the distributor cap on correctly? Anyone have pictures of an engine bay from different angles?

 

[SilverMk2]

The top line off the PS check valve goes in to the intake pipe in front of the TB. The lower one goes over to the intake manifold above the ISC valve. The dist. cap can only go on one way. The angle between the screws is different all around. Anyway the 3 outward terminals point forward.

 

[ma71supraturbo]

The top line off the PS check valve goes in to the intake pipe in front of the TB. The lower one goes over to the intake manifold above the ISC valve.

Thanks! Do you happen to know about the nipple below the brake booster? And does a semi-large hose go into the intake pipe from the ISC?

The dist. cap can only go on one way. The angle between the screws is different all around. Anyway the 3 outward terminals point forward.

Thanks again, I have the type of distributor cap that have all the terminals coming straight out, but I lined up the rotor tower #1 with the engine at TDC so I guess it went on correctly.