Toyota Celica Supra Forum banner

1 - 3 of 3 Posts

·
Registered
Joined
·
312 Posts
Discussion Starter #1
As the title states looking for a one piece driveshaft. Steel or aluminium. I know I can get one custom made but thought I would check on here first if someone has one laying around or going a different direction with their setup.

I'm running a 7mgte motor with an R154 tranny. Prefer a slip yoke to fit.

Thanks
Nick

Sent from my LM-V350 using Tapatalk
 

·
Super Moderator
Joined
·
8,135 Posts
So I have a steel one piece that is R154 to stock Mk2 flange in the rear. It has maybe a couple of thousand miles on it. Catch would be that with my 2JZ it was ever so slightly too long and was cutting the rear oil seal. I had no problems with it when I had a 7M. I just ended up doing a new aluminum one that was like an 1/8" shorter. I'd give it to you for $10 + shipping just to cover gas and tape. Catch is that shipping is probably like $50 since its so heavy and large. LMK if you're interested.
 

·
Registered
Joined
·
312 Posts
Discussion Starter #3
So I have a steel one piece that is R154 to stock Mk2 flange in the rear. It has maybe a couple of thousand miles on it. Catch would be that with my 2JZ it was ever so slightly too long and was cutting the rear oil seal. I had no problems with it when I had a 7M. I just ended up doing a new aluminum one that was like an 1/8" shorter. I'd give it to you for $10 + shipping just to cover gas and tape. Catch is that shipping is probably like $50 since its so heavy and large. LMK if you're interested.
Awesome dude! Sounds like exactly what I need. Definitely interested. I'll pm you.

Sent from my LM-V350 using Tapatalk
 
1 - 3 of 3 Posts
Top